This software is released under the GNU General Public License. See the file named COPYING for details.
Further information can be found in the doc directory
----ooooOOOOoooo----
Generic installation instructions can be found in the file named INSTALL.
Briefly, it's just:
$ ./configure
$ make
and
$ make install
to install the plugins.
It is assumed that the LADSPA SDK is installed under /usr - you can change this by supplying the path to configure using --with-ladspa-prefix.
If you want the plugins to be installed somewhere in particular, use the --with-ladspa-plugin-dir option (make sure that the path supplied is in your $LADSPA_PATH!)
If you want smaller wavedata, use the --enable-small-wavedata option. This trades off accuracy against size. It still sounds good though...
Finally, if you already have plugins with the same name as any of the blop plugins, you can use --program-prefix=blop_ (or something else) to ensure the existing ones are not overwritten. Alternatively, just put them in a new directory....
If you have installed liblrdf, there is an rdf metadata file: doc/blop.rdf - copy this to wherever you keep your rdf's
----ooooOOOOoooo---- Building from CVS:
- Versions
- autoconf 2.58 automake 1.5 gettext 0.12.1
After initial checkout, you need to run gettextize to set up symlinks to installed gettext bits and pieces:
$ gettextize -f --no-changelog
You'll then need to prepare the build cruft:
$ aclocal -I m4
$ autoheader
$ autoconf
$ automake -a