New features in wcnt-1.25
- group
- group modules together then the whole group can be copied.
- copier
- copy single data objects and modules.
- peak_detector
- output a message when the input signal falls outside a specified range.
- adder
- add two signals together.
- subtracter
- subtract a signal from another.
- simple_delay
- a simple delay.
- trig_delay
- delay a trigger.
- stepper
- takes a step through a shape of values each time it is triggered.
new features in wcnt-1.128
* time_map
- tempo changes have been changed so that you add or
subtract from the existing tempo, instead of specifiying
an absolute value to set the bpm at.
- sequencer
- new implimentation of note slide handling. It now remembers notes to slide back to.
- slight improvements made to time keeping code.
- no longer provides out_end_trig when out_start_trig requested
- removed a redundant parameter hold_notename
- adsr
- release section can now only be triggered once. subsequent note_off triggers which occurr before a note_on have no effect.
- min_time parameter, specifies minimum time adsr can run before note_off.
- max_sustain_time, specifies maximum time sustain section can hold.
- release_is_ratio (on/off) turns levels in release section to
ratios.
- osc_clock
- response_time parameter added.
- in_play_state input added. used in combination with response_time
parameter. when in_play_state input is on, take n milliseconds to
change frequency. when in_play_state is off, ignore response_time.
- logic_trigger
- new function - xornot. only trigger if trigger1 triggers, but not if trigger2 triggers simultaneously.
- precision parameter added. tells the logic_trigger how many samples
may elaspe between in_trig1 and in_trig2 triggering and still treat
them as occurring simultaneously.
- sync_clock - new module
- a LFO-like clock module which keeps in time with tempo via inputs connected to a time_map module.
- quarter_value and note_length parameters specify how fast to tick.
- phase can be reset.
- can be connected to sine_wave module etc.