aaflip -- an ascii arted flic player for aalib
Version 0.3
This is modifies version of flip(flic animation file player, see bellow)
that works in text mode.
ORIGINAL FLIP README
flip -- a flic file player for the Linux console
Version 0.3
By John Remyn
This is a non-X flic animation file player for Linux. A VGA compatible card is required.
Flic files can usually be recognized by the .fli or .flc extensions at the end of their filenames. Fli files are limited to a resolution of 320x200, while flc files can have any resolution.
The binary requires svgalib to be installed (svgalib can be found at sunsite.unc.edu:/pub/Linux/libs ).
The default method of playing is to load the first frame of the animation sequence and display it. After this the remainder of the flic file is loaded into memory, and the animation starts. The animation ends when q or ctrl-c is pressed. There are some flags that control the way the flic file is handled:
-a Remove frames from memory after processing. Using this option
leaves more memory for other processes, but relies on the buffer
cache for continuous animation.
-b Process frames immediately as they are loaded. When using this
option the animation frames are shown as soon as the player has read
them, so you don't have to wait until the entire file has been
read. The disadvantage is that the animation becomes jumpy if the
speed set by the animation is higher than the speed of loading.
-c Keep the screen black while loading the animation. This conflicts
with option b, which can give interesting results.
-f This removes the clock synchronization. This is just for fun, so
you can show off the speed of your computer :-)
-n <number>
Play the flic file <number> times.
-s <delay>
Sets the delay between frames to <delay>*0.01 seconds. Option -s 0
is the same as -f.
- Causes flip to read the flic file from stdin. Using this with option
-a may cause trouble since backward seeks are done.
Other options are:
-v Shows some information about the flic file being played.
-? Shows a bit of help.
Flc files:
Flc files with resolutions higher than 320x200 are now supported, out of the
3 files I could find, 2 work OK, 1 works almost OK.
There are some considerations to be made when playing big flic files. If the
file fits completely into memory, there are no problems. However when memory
is short Linux swaps pages out of memory, which can happen while a frame is
being decoded. This is not only slow but also results in very ugly
animation. Animation improves when option -a is used, in which case there
will be much less swapping (there still is a lot of disk/buffer-cache access
going on though). Using option -b is also advisable since the animation
won't be smooth anyway.
Bugs:
- X and Y offsets are not handled.
- Flic files with resolutions smaller (or bigger) than the screen size are
probably not handled correctly, but I have yet to see one.
- At least one of the flc files I have displays a few pixels of trash in a
place where they should definately not be. This could be caused by
incorrect handling of a page break. When I feel motivated enough I'll try
and fix it.
Release history:
V0.3a Added support for FLC files with resolutions greater than 320x200.
(A real pain)
V0.2a Added decoding of DELTA_FLC chunks, so some flc files can also be
played. Changed the command line parameters. Removed some small
bugs.
V0.1 First release, only just capable of playing fli files.
John Remyn (author) (boogyman@xs4all.hacktic.nl may work soon) Harm Hanemaayer hhanemaa@cs.ruu.nl (for mail)